Foxy brushed motor 600 7.2V # 3BD1025
The direct current motors of the FOXY Brushed series are perfect for a whole range of model making applications - for powering airplanes, ships, cars, tanks and other land vehicles with direct drive and gearbox.
When installing and connecting FOXY brushed motors, make sure that you do not exceed the permissible values for supply voltage and current load.
Cooling of the motor: During operation, the temperature of the outer casing of the motor should not exceed 80 ° C. In the model it is therefore always necessary to ensure sufficient access to the cooling air and its flow around the engine. We recommend the use of water cooling for ship models. High engine loads are only possible for a short time. After every flight / drive, the engine must cool down to room temperature before you start again.
FOXY 600 7.2 V is a direct current electric motor of size "550" with a shaft 3.175 mm in diameter and plain bearings, which is used to drive aircraft models (e.g. motor gliders with a span of 1800-2000 mm) with direct drive (7x4 "propeller) or with gear, for small cars and ship models (ship propeller 30-35mm) is suitable.
To control its speed you need an electronic controller with a load capacity of 30-40 A.
FOXY 600 7.2 V is a suitable replacement for the Speed Motor 600 7.2 V (catalog no. 1793).
Technical specifications:
Nominal voltage 7.2 V.
Operating voltage range 3.6 ... 8.4 V.
Idle speed 18,500 min -1
Regulator 30-35A
Length: 57mm
Diameter 36mm
Shaft 3.17mm
Weight 235g.
The motor set contains:
The FOXY 600 7.2 V motor
The instruction