Foxy Brushed Motor / Brushed 700 Race 9.6V # 3BD1040 (Speed 700 Race 6318)
he direct current motors of the FOXY Brushed series are perfect for a whole range of model building applications - for powering aircraft, ships, cars, tanks and other land vehicles with direct drive and gearbox.
When installing and connecting FOXY brushed motors, make sure that you do not exceed the permissible values for supply voltage and current load.
Cooling of the motor: During operation, the temperature of the outer casing of the motor should not exceed 80 ° C. In the model it is therefore always necessary to ensure sufficient access to the cooling air and its flow around the engine. We recommend the use of water cooling for ship models. High engine loads are only possible for a short time. After every flight / drive, the engine must cool down to room temperature before you start again.
FOXY 700 Race 9.6 V is a direct current electric motor of size "700" with a shaft 5.0 mm in diameter and plain bearings, which is used to drive aircraft models with direct drive (9x4 "propellers) or with gearboxes, for small car and ship models ( Ship propeller 35–40mm) is suitable.
To control its speed you need an electronic controller with a load capacity of 60–80 A.
FOXY 700 Race 9.6 V is a suitable replacement for the Speed Motor 700 Race 9.6 V (catalog no. 6318).
Technical specifications:
Nominal voltage 9.6 V.
Operating voltage range 4.8 ... 20.0 V.
Idle speed 18,000 min -1
Regulator 60-80A
Length: 66mm
Diameter 42mm
Shaft 5mm
Weight 370g.
The motor set contains
The FOXY 700 Race 9.6 V motor
The instruction