Konect | Hobbywing Brushless Car Controller | 1/8 & 1/10 | 80A | Waterproof # KN-8BL80-SCT-WP
Konect & HobbyWing are your reliable partner when it comes to getting the maximum performance out of your RC car.
The 80A continuous load controller is waterproof and has a switched BEC which provides 6V with 5A power. This means that even high-torque and high-current servos can be operated without any problems.
Equipped with two DEAN / T plugs, two batteries can be connected to the brushless controller without additional adapters. The motor is already equipped with high-quality 4mm gold contacts and can be connected to the controller right away. This means that the system is immediately ready for use without any further soldering work, i.e. real plug & play.
The Konect 100A WP controller can be easily programmed with a separate programming connection and a programming card (optional) without having to disconnect the existing connections in the vehicle beforehand. In this way, the numerous functions of the brushless controller can be adapted to your own needs in no time at all and without major complications. Alternatively, it can of course also be programmed using the built-in setup button on the switch.
Last but not least, the controller also has a number of safety systems to protect the electronics such as LiPo battery, remote control, controller and servos from damage due to, for example, reverse polarity, overheating, short circuit or undervoltage.
FEATURES:
This electronic brushless speed controller is ideal for vehicles in 1/8 scale when it is to go off-road. No matter if buggy, short course, stadium truck or truggy with the Konect controller 100A WP (produced by the market leader HobbyWing) you will have maximum driving fun, mega performance and zero problems. However, this controller is the first choice for larger and heavier 1/10 vehicles such as 4WD Monster Trucks or Short Course models with all-wheel drive, provided that a motor with 42mm outer diameter can be installed.
Waterproof & Dustproof Regulator
Powerful 6V BEC with 5A
Dual port for connecting the fan or the programming card
On / off switch including a separate setup button
Proportional brake with 9 different programs for maximum braking force and drag brake (automatic braking force in idle / neutral position)
The maximum braking force can be set in 5 different modes from 25% to 100% or completely off.
9 adjustable acceleration curves / punsh from soft to mega aggressive acceleration
Reverse gear can be deactivated
In LiPo mode, the lower voltage limit can be set almost continuously from 2.6V / cell to 3.4V / cell. If desired, this can also be completely deactivated
complete ready for connection for battery & motor (plug & play) no soldering necessary
TECHNICAL SPECIFICATIONS
Continuous current: 80A
Peak current: 550A
Input voltage: 2-4S LiPo batteries, 6-12 cells NiMH / NiCd batteries
BEC output power: 6V / 5A (switch mode)
Motor limits: 2S LiPo operation: KV <= 6000, 3S LiPo operation: KV <= 4000, 4S LiPo operation: KV <= 2600
Type: Sensorless system
Connector system: On the battery side, 2x Dean / T connector (for connecting two batteries)
ESC / Motor: 4mm gold contact sockets
Recipient: JR / Graupner
Dimensions approx .: 59.5 x 48 x 42
Weight: 165g
RECOMMENDED USE
1/8 buggy
1/8 short course
1/8 truggy
1/8 monster
1/10 Monster (note motor size)
1/10 Truggy & Trucks (note motor size)
1/10 short course
